Home

About

Products

Ordering

Support

Contact

 

POD-DIAG40 Construction

The POD-DIAG40 has a male 40-pin DIP connector that plugs into the PAC-DIP40. The function of this connector is connect each pin on the left to each pin on the right with a series of 20 jumpers. i.e. pin 1 is connected to pin 40, pin 2 is connected to pin 39, ..., pin 19 is connected to pin 22, and pin 20 is connected to pin 21.

For the voltage measurements gnd is pin 20, JP1 is pin 19, JP2 is pin 18, and JP3 is pin 17. Please note that voltages are only applied for about 30 seconds.

[ Go Back to the FLEX-700 / TUP-500 Software Page ]



Copyright 2005 Tribal Microsystems, Inc. All rights reserved.
Home About Products Ordering Support Contact
  Tribal Microsystems is the place to find the Device Programmer or EPROM Programmer your company needs, at a price you can afford.