System parameters:
Remarks: The SX-8 series is offered in numerous models but most of these are just frames that house a smaller amount of the same processors. We only discuss the essentially different models here. All models are based on the same processor, an 8-way replicated vector processor where each set of vector pipes contains a logical, mask, add/shift, multiply, and division pipe (see section SM-SIMD systems for an explanation of these components). As multiplication and addition can be chained (but not division) the peak performance of a pipe set at 2 GHz is 4 Gflop/s. Because of the 4-way replication a single CPU can deliver a peak performance of 16 Gflop/s. The official NEC documentation quotes higher peak performances because the peak performance of the scalar processor (rated at 4 Gflop/s, see below) is added to the peak performance of the vector processor to which it belongs. We do not follow this practice as a full utilisation of the scalar processor along with the vector processor in reality will be next to non-existent. The scalar processor that is 2-way super scalar and at 2 GHz has a theoretical peak of 4 Gflop/s. The peak bandwidth per CPU is 64 B/cycle. This is sufficient to ship 8 8-byte operands back or forth and just enough to feed one operand to each of the replicated pipe sets. Unlike from what one would expect from the naming the SX-8B is the simpler configuration of the two single-frame systems: it can be had with 1–4 processors but is in virtually all other respects equal to the larger SX-8A that can house 4–8 processors. There is one difference connected to the maximal amout of memory per frame: NEC now offers the interesting choice between the usual DDR2-SDRAM or FCRAM (Fast Cycle Memory. The latter type of memory can a factor of 2–3 faster than the former type of memory. However, because of the more complex structure of the memory, the density is about two times lower. Hence that in the system parameters table, the entries for FCRAM are about two times lower than for SDRAM. The lower bound for SDRAM in the SX-8A and SX-8B systems are the same: 32 GB. For the very memory-hungry applications that are usually run on vector-type systems, the availability of FCRAM can be beneficial for quite some of these applications. In a single frame of the SX-8A models fit up to 8 CPUs. Internally the CPUs in the frame are connected by a 1-stage crossbar with the same bandwidth as that of a single CPU system: 64 GB/s/port. The fully configured frame can therefore attain a peak speed of 128 Gflop/s. In addition, there are multi-frame models (SX-8xMy) where x = 8,...,4096 is the total number of CPUs and y = 2,...,512 is the number of frames coupling the single-frame systems into a larger system. There are two ways to couple the SX-8 frames in a multi-frame configuration: NEC provides a full crossbar, the so-called IXS crossbar to connect the various frames together at a speed of 8 GB/s for point-to-point unidirectional out-of-frame communication (1024 GB/s bisectional bandwidth for a maximum configuration). Also a HiPPI interface is available for inter-frame communication at lower cost and speed. When choosing for the IXS crossbar solution, the total multi-frame system is globally addressable, turning the system into a NUMA system. However, for performance reasons it is advised to use the system in distributed memory mode with MPI. For distributed computing there is an HPF compiler and for message passing an optimised MPI (MPI/SX) is available. In addition for shared memory parallelism, OpenMP is available.
Measured Performances: |