Analog Devices

Products

Engineered. Tested. Ready to Integrate.

Browse Circuits

ADL5324 400 MHz to 4000 MHz ½ Watt RF Driver Amplifier

ADuM3223 3 kV rms Isolated Precision Half-Bridge Drive

multisim MultiSIM

MultiSIM
NI Multisim™ Component Evaluator - Analog Devices™ Edition is a free, downloadable version of National Instruments Multisim 12 Circuit Simulation Software, tailored for evaluating ADI components.
Filter Filter

Filter
Analog Filter Wizard™ helps you select and design in an operational amplifier that fits your filter application needs. It works in conjunction with the Active Filter Synthesis Design Tool which together will guide you through the filter application design process. These steps include entering filter criteria, reviewing recommended parts, active filter synthesis design, and finally generating a Bill of Materials and/or SPICE Netlist.
Amp Tools Amp Tools

Amp Tools
View all tools available for Analog Devices' Amplifiers products.

ADIsimADC ADIsimADC

ADIsimADC
The ADIsimADC tool is an aid to help in the selection of Analog to Digital Converterse (ADC's), perform evaluations and assist with troubleshooting. The tool uses typical data values to mathematically model the general behavior of the selected ADC. It allows a user to apply input signals, set encode (sample) rates and simulate FFT's on a selected ADC. It is useful for checking the SNR, SFDR, SINAD, THD, ENOB etc. of a selected ADC.
ADIsimDAC ADIsimDAC

ADIsimDAC
ADIsimDAC assists the user with finding Analog Devices' DACs and DAC Application Circuits. It takes user inputs along Typical Parametric Data to sort, select and suggest applicable DAC's, system components and circuit solutions.
ADC/DAC Tools ADC/DAC
Tools

ADC/DAC Tools
View all tools available for Analog Devices' Data Converters products.

ADIsimRF ADIsimRF

ADIsimRF
ADIsimRF is an easy-to-use RF signal chain calculator. Cascaded Gain, Noise Figure, IP3 and P1dB as well as total power consumption are calculated. The number of stages can be varied up to a maximum of 15. Additional stages can be inserted at any point in teh signal chain and individual stages can be temporarily disabled or deleted. The calculator can be switched between Transmit Mode and Receive Mode where calculations are presented output-referred and input-referred respectively.
ADIsimPLL ADIsimPLL

ADIsimPLL
The ADIsimPLL design tool is a comprehensive and easy-to-use PLL synthesizer design and simulation tool. All key non-linear effects that can impact PLL performance can be simulated, including phase noise, Fractional-N spurs, and anti-backlash pulse. ADIsimPLL design tool eliminates time-consuming iterations from the PLL/synthesizer development process.
RF Tools RF Tools

RF Tools
View all tools available for Analog Devices' RF ICs.

ADIsim Power ADIsim
Power

ADIsimPower
ADIsimPower™ Voltage Regulator Design Tool produces custom DC-DC converter designs in about one minute. The user enters 5 inputs and chooses to optimize for efficiency, PCB space, cost, or part count. Output is a complete schematic, BOM, efficiency plot, and performance summary. A PDF summary and a blank PCB is offered for each design to facilitate fast prototyping to verify the design.
Digital Power Management Digital Power
Management

Digital Power Management
ADI's digital PWM (pulse-width modulation) power control and management devices provide designers with a highly integrated circuit architecture and the flexibility to configure system power-supply parameters in a matter of minutes using an intuitive GUI (graphical user interface). Power design egnineers with no prior programming experience can use the GUI to monitor and quickly adjust power functions such as frequency, timing, voltage settings, and protection limits.
Power Tools Power
Tools

Power Tools
View all tools available for Analog Devices' Power Management products.