After much debate and a lot of contention among the overall IEEE membership, the all-important IEEE 802.11n working group has given its stamp of approval to the next draft version of the specification.
Cisco to allow role-sharing in channel partner program
RE: Nortel shares next-gen wireless strategy
8th annual system administrator appreciation day is Friday, July 27th, 2007
E-Mail article | |
Print article | |
Contact author | Reprint |
AIM article | del.icio.us |
Digg | |
Stumble | Slashdot It! |
Temporarily dubbed draft version 1.10, it will go out as version 2.0 when it is released to the full IEEE 802.11n committee, about 400 strong, by the end of the month.
According to Bill McFarland, a member of the working group just back from the London meeting where version 1.10 was approved, all of the contending parties who caused the original delays appear to be satisfied.
This includes the handset and handheld manufacturers who wanted more consideration given to low power consumption and VOIP capabilities, consumer electronics manufacturers who wanted the standard to accommodate more than access points, and the major hardware network and chip manufacturers who wanted to put the 802.11n spec on a fast track to approval.
Manufacturers like Atheros, Intel, and Apple and their customers will be happy to hear that version 1.10 is compatible with the pre-802.11n products they have already created.
"It will only require a minor firmware upgrade for complete compatibility," said McFarland.
The major change was around the implementation of the 40MHz channel. It has been adjusted to accommodate older 2.4GHz band devices, which may be confused by the wider channel bandwidth.
The new spec calls for the use of two 20MHz bands. Under version 2.0, the system will scan the environment looking for legacy devices that might not understand the wider bandwidth, in which case the 802.11n device will back off and send data over only a single 20GHz band. While this would slow down overall data throughput to a single 20MHz channel, 802.11n's MIMO (Multimedia In Multimedia Out) technology will still give 802.11n faster performance.
A second change will allow an 802.11n device to check to make sure both channels are clear before sending data. A third change allows devices, such as Bluetooth-enabled devices, to send a signal saying it does not want to receive data in the 40MHz mode. Continued
For more enterprise computing news, visit InfoWorld. Story copyright InfoWorld Media Group, Inc.
Note: Register to have your user name appear; otherwise your comment will show up as "Anonymous."
*Anonymous comments will only appear once they are approved by the moderator.
Copyright 2007 Network World Inc.
Apple iPhone 'first look' |
What Network Worlders are talking about:
Rebates: ProCurve Switch 1400 and 1700 series
Get rebates on the new Procurve Switch 1400 and 1700 series by HP. Purchase before July 31, 2007.
Rebates: ProCurve Switch 1400 and 1700 series
Get rebates on the new Procurve Switch 1400 and 1700 series by HP. Purchase before July 31, 2007.
Fast, Secure Wireless
Help employees be more productive & responsive at the office or on the road
New Webcast: How to Profit with Remote Support
Discover how remote support can fuel your IT business in ways you've never thought of before.
RE: IEEE 802.11n working group approves draft 2.0 By tonmoy on July 9, 2007, 9:54 am Reply | Read entire comment When it will launch and what will be its maximum speed? Re: IEEE 802.11n working group approves draft 2.0.
All comments (1)