Open source tool detects videoconferencing equipment vulnerabilities

by Ses Wang - Qualys - Friday, 17 February 2012.
Bookmark and Share

Videoconferencing equipment has been in the news recently for its potential for use by attackers to snoop on confidential company meetings, view charts mounted on meeting room walls, or listen in on conversations stealthily. While this is not a new vulnerability per se, and videoconferencing equipment has been usable for more than a decade in this way, I thought it would be interesting to build and release an open source tool that could detect whether a given videoconferencing system is vulnerable to these attacks. That tool is now complete and available as

In this article, I explain the underlying videoconferencing protocol, how it is vulnerable, and how the tool detects the vulnerability. I also discuss why we decided to release this tool rather than fully enabling it in QualysGuard at this time.

What is Auto-answer?

‘Auto-answer’ is the ability to accept incoming calls or requests automatically without or with very little prompting. ‘Auto-answer’ is enabled by default in most videoconferencing equipment, and can allow an attacker to ‘join’ a videoconference by stealth.

Videoconferencing and H.323

H.323 is a recommendation from the ITU Telecommunication Standardization Sector (ITU-T) that defines the protocols used to provide audio-visual communication sessions on any packet network. Most videoconferencing equipment uses the H.323 protocol stacks, which contain the protocols as shown below:

In the TCP/IP layering model, H.323 sits at the application layer and uses the TCP/UDP services provided to transmit H.323 packages in a TCP/IP based network. H.323 uses Q.931, the ITU standard ISDN connection control signaling protocol, to establish connections. When the Q.931 connection has been successfully set up, videoconferencing initiation is implied. Below is how Q.931 connection is set up:
  • Caller A sends a ‘SETUP’ message to Caller B
  • Caller B sends a ‘ALERTING’ message to Caller A, indicating an incoming call
  • Caller B answers the call and sends a ‘CONNECT’ message to Caller A.
Once the Q.931 connection is established, both A and B can start their videoconferencing. If Caller B has ‘auto-answer’ enabled, Caller B will directly reply with a ‘CONNECT’ message without the ‘ALERTING’ step, initiating the videoconferencing session without the incoming call indicator.

Detecting 'Auto-answer' enabled with tool

The ‘’ tool needs two parameters, an IP address and a port number, and can be run as shown in the screen capture below. The tool also displays other information from the remote equipment like the Manufacturer ID and Product ID:

 1  |  2  |   Next page >>