Cuz-D Straight Flush Saw: with dust extractor
A good contractor knows how to multitask.
So does his saw.

Let’s face it, you perform multiple jobs everyday, why shouldn’t your saw? The Cuz-D Straight Flush Saw not only cuts straight and flush, it can multi-task like a contractor on his fifth cup of coffee. It can undercut, plunge cut, bevel cut, nose cut, and much more. It can even tackle a 6-inch beam in two passes. If only every helper on the jobsite worked this hard.

Watch the videos. See for yourself.

Subfloor challenge

If you have to remove a subfloor, this is your animal. The Cuz-D patented zero-clearance blades allow you to perform zero-clearance flush cuts that track straighter than any other worm-driven saw. You can set the angle of the blade to 5 degrees and cut right against the wall, without damaging the sheetrock or baseboard.

Beam challenge

The standard way to cut a 6-inch beam is four passes with a circular saw, then finish off the remaining center portion with a reciprocating saw.  With the Cuz-D, the job is done in two passes. 

Under cut

The Cuz-D lets you to adjust the rear handle 90°, providing better control than a traditional under cut saw.  

Bevel cut

The Cuz-D can perform a variety of bevel cuts. In fact, its base plate can be adjusted to a maximum of 65° and a even a minimum of 5°.

Guard trigger

Have you ever jerry-rigged a saw with a pencil to hold the guard open? It’s a pretty common practice. It’s also pretty dangerous. See how the Cuz-D solves this problem.

3⅛” cut depth

The Cuz-D’s 3⅛” cut depth lets you rip through 2×4’s at twice the speed. See for yourself.

Cuz fast.